Hi, I'm new. Just wanted to get that out of the way before I post a question here. And also, who's ***** do I get to be?
Anyway, I have a Soyo K7V Dragon plus. I setup a Raid 0 configuration with two WD 10.2g HDs. All was working fine whilst installing Windows 98. Everything loaded fine, then I installed the raid driver. After this, the hd LED stays on during inactivity and I start getting BSODs when there is a lot of disk activity. It says:
Error writing to drive C:
Then, the entire system just locks. I have flashed my bios, and reloaded windows 98 to no avail. I even loaded windows 2000 (fresh) and tried the 2000 driver. Still no luck. I think it is something with the driver because I don't have problems until after it is loaded. I have e-mailed Soyo about this problem and they said they will do lab tests and get back to me. I don't think I will hear from them again. Plz hlp!
:confused:
Anyway, I have a Soyo K7V Dragon plus. I setup a Raid 0 configuration with two WD 10.2g HDs. All was working fine whilst installing Windows 98. Everything loaded fine, then I installed the raid driver. After this, the hd LED stays on during inactivity and I start getting BSODs when there is a lot of disk activity. It says:
Error writing to drive C:
Then, the entire system just locks. I have flashed my bios, and reloaded windows 98 to no avail. I even loaded windows 2000 (fresh) and tried the 2000 driver. Still no luck. I think it is something with the driver because I don't have problems until after it is loaded. I have e-mailed Soyo about this problem and they said they will do lab tests and get back to me. I don't think I will hear from them again. Plz hlp!
:confused:
Comment