If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hello folks, I was wondering if it was possible to detect whether your Dual DDR setup is working i.e. if it is actually running the dual setup or still in single setup.
If you are running a p4 board then there should be 4 slots.
----a
----b
----1
----2
like that. IF you put your identical ddr rams, they have to be same speed same everything, dual set up would be a and 1 together or b and 2 together.
On some AMD systems I have built (MSI boards) it tells you on the POST screen. Its that black screen with the mem test and IDE devices listed. Should just say:
Hi, I have a MSI K7N2-Delta mobo, 2x512 MB Twinmos DDR 400 CL 2.5 , AMD XP 2600+.
In the boot screen it only says DDR 400 or DDR 333 acording to the setings i have put in the bios. Doesn´t say nothing like:
Memory Mode: Dual Channel
or
Memory Mode: Single Channel
Any idea why?
My bios version is 5.1 (4/18/2003). Do you think i need to flash the bios?
Thanks
Comment